Get Started: Learn How To Change A Broken Cord On A Sash Window

As sash windows age, so do the cords. They can break as time goes on. Fixing them, however, does not require one to be rich. As a matter of fact, no home improvement experience or expertise is needed. The tips that follow will explain How to change a broken cord on a sash window.

One must begin by putting the tools together that are necessary for the project. A few of those are a utility knife, a screwdriver and a lubricant. Some more tools that are important to have are a hammer, new cord roping and a putty knife. At the point the tools have been gathered, the window must be removed from its frame.

Following window removal, the next step is to gain access to the sash cord. There are panels on some windows. However, older windows could be without them. If so, then, in addition to removing the window, the window casing needs to be removed.

The first step is in getting to the sash cords. Those windows that have an access panel will have it on the side jambs. Inside the panel are the weights, the pulleys and the sash. At the time that access is made, any old cord on the sash weights and the weights themselves need to be taken out. Once the cord roping is detached, put the weights back. They should be put on top of a wood block that is four to five inches thick.

The next step is to lubricate the window pulleys. Make sure they are clean first. If not, clean them before spraying with a lubricant. Following that step, do what it takes to make feeding the rope through the pulley easier. One way to do this is to tape the end of the new cord to the end of the old cord. Of course, the next step is to feed the rope through the pulley. Withdraw the old cords from the access panel. As the old cords are removed, the new cords will be fed through the pulley.

Put the cord through the hole in the weights. Then, tie a knot at the bottom of the cord. Typically, there is just one knot and it is placed in a groove that is fitted. It will usually run a couple of inches past the pulley hole. Repeat the previous steps again on the other side. As soon as the basics are completed, then trim and finish nails should be put back. It is also possible, based on a person’s wishes, to select a finish and a stain to go with the room’s decor and atmosphere.

It is not necessary to be a home improvement professional in order to fix a broken sash window cord. It also does not take much time. A little bit of time in an afternoon, the proper tools and the correct instructions will make changing cords possible. Follow these steps and one will know How to change a broken cord on a sash window.

Looking for more information on how to change a broken cord on a sash window ? Get the low down instantly in our overview of sash cord repairs and all you need to know about sash window repairs London .

Share this Post:
Digg Google Bookmarks reddit Mixx StumbleUpon Technorati Yahoo! Buzz DesignFloat Delicious BlinkList Furl

No Responses to “Get Started: Learn How To Change A Broken Cord On A Sash Window”

Leave a Reply:

You must be logged in to post a comment.